My new engine, 425ci smallblock, 565hp n/a
#1
slo truk
Thread Starter
Join Date: Sep 2006
Location: Chesapeake
Posts: 601
Likes: 0
Received 0 Likes
on
0 Posts
My new engine, 425ci smallblock, 565hp n/a
It's finally done! Went on the engine dyno today, 565hp 525tq n/a. This dyno reads low too, it's like the Mustang dyno of engine dynos LOL My builder says that based off of other similar setups and my race weight (3900lbs), it could go high 10's on the motor (10.7 actually, but without the suspension for it, I'll be lucky if it cracks a 10.9). My goal is to run on the motor at least what I ran on the blower, 11.3's, so sounds like she could do it
Oh, and it's actually built for nitrous, it'll be getting a 300 shot from a plate setup
A friend of mine has vids of the break-in and dyno pulls, I'll post the links as soon as he uploads them.
Specs:
59* R3 race block (non-siamese)
4.10" forged crank
6.20" forged rods
Custom N20 JE pistons & Hellfire rings (4.060" bore)
11.2:1 compression
Dakota custom oil pan
CSR Reverse flow Magnum water pump
Custom Bullet Hyd Roller.... 262/270 @ .050" 108 LSA, .602"/.585"
Crane retrofit rollers
W5's flow 320/220
ICH 360-3R manifold
T&D 1.65/1.5 rockers
Oh, and it's actually built for nitrous, it'll be getting a 300 shot from a plate setup
A friend of mine has vids of the break-in and dyno pulls, I'll post the links as soon as he uploads them.
Specs:
59* R3 race block (non-siamese)
4.10" forged crank
6.20" forged rods
Custom N20 JE pistons & Hellfire rings (4.060" bore)
11.2:1 compression
Dakota custom oil pan
CSR Reverse flow Magnum water pump
Custom Bullet Hyd Roller.... 262/270 @ .050" 108 LSA, .602"/.585"
Crane retrofit rollers
W5's flow 320/220
ICH 360-3R manifold
T&D 1.65/1.5 rockers
#5
A.K.A Slowintegra92
Join Date: Mar 2004
Location: Yorktown
Posts: 613
Likes: 0
Received 0 Likes
on
0 Posts
#8
slo truk
Thread Starter
Join Date: Sep 2006
Location: Chesapeake
Posts: 601
Likes: 0
Received 0 Likes
on
0 Posts
Re: My new engine, 425ci smallblock, 565hp n/a
592rwhp on 18psi, but never got any good track runs on that setup, had a lot of fuel issues. Not sure what it was making when it ran 11.3's.
I punched the #'s into a few different calculators and they're saying 11.0. Unfortunately, it'll be June before I can find out.
#9
slo truk
Thread Starter
Join Date: Sep 2006
Location: Chesapeake
Posts: 601
Likes: 0
Received 0 Likes
on
0 Posts