Brock Obama

The transmission in my '90 CRX DX is on it's way to a better land. When I down shift, it will make a whining, almost grinding sound. Also, when the car is in neutral and the clutch is up, it will make the same sound. This particular sounds directly corresponds with the revolutions of the engine. Also, whenever I push in the clutch, the sound will completely go away.

Input shaft bearing?? Anyone selling a transmission? Thanks

joshuaa3

try putting some gm synchromesh fluid in it.

Brock Obama

I will try that.

About a year ago, I replaced and refilled it with 5W-30.

J. O. BUDS

throwout bearing, period, indent paragraph

BCisme

It's time to move on B-rock. Just let it happen.

Lestar

That's what I was thinking.

lazyazn

The junkyard in Mt Airy have one crx there. Saw it there on monday, so it should still be there. It's like 75 dollar for tranmission there.

The real Ryan

Agreed. Brock you didn't replace the TOB when you put the new clutch in did you?

accuracy1

With the clutch pedel disengaged off the floor the throwout bearing does not touch the clutch.
It has a bad mainshaft bearing. It is very common with that tranny.

The real Ryan

Throwout bearing. I only say that b/c I bet that Brock didn't replace the old one when he put in the new clutch. However, there is still a chance of it being the input shaft bearing.... Brock, I would pull the inspection plate from the bottom of the tranny and see if there is any trace of tranny fluid leaking. I bad input shaft bearing will cuase the shaft to "wobble" and it wears the input shaft seal out causing tranny fluid to leak out all over the clutch and flywheel.