240SXCr4zY

honda board?? im sorry i failed to see where it says anything "honda va"

flow fx

80-90% of this board are Honda guys.. we do have quite a few 240 guys though.. nowhere near the number

Ill pm about the cobra in a few

IC x Prince

cali sucks ass.

Jay

Damn... and I was looking forward to S.D. next week.

FumingSmoked

Good Luck with the swap. The car will be badass once done.

soulDistortion

Like spinnydrift said, it's a huge pain in the ass to do, and a huge pain in the ass to maintain. It's not that it's unrealistic, it's just that you're going to be sinking a lot of time and money into this project.

But... if you're actually serious:

You don't need an R31 tranny, per se. Any RB25DET transmission will work fine.

Oh, and go to this site: http://www.mckinneymotorsports.com/

They've been doing RB swaps into 240s for awhile, and sell all the random crap you'll need to make it work (adapters, crossmembers, downpipes, etc.).

Flite

Grey at Millenium is doing this swap I believe...try them.

MGBRaceman

I believe the RB26DETT was from the most recent R34 skyline, not the R32, so the motor may be more difficult to get ahold of than you think. I have heard that the swap is a pain in the ass, as others have told you. Also, the block is cast iron, unlike the Sr20, so you're going to front out your weight distribution if you're interested.

EEK

it will fit with a single turbo conversion..but i rather go with a fully built KA

dragging240s

If this is the same one I heard that they finished it but were disappointed in the numbers it put out. Of course I could have heard wrong.