Three KA24s = one DOHC Inline 6 head
10-26-2010, 03:10 PM
#1
nortaP
Thread Starter
Join Date: Feb 2009
Posts: 13,272
Likes: 0
Received 0 Likes
on
0 Posts
Three KA24s = one DOHC Inline 6 head
From an old thread on anthoer forum I forgot about,
Guy takes three KA24 heads, cuts them up, and assembled them into a single DOHC head for a Nissan L28 inline 6.
I remember when he started talking about this project back in 2005 or so, and in 2007 he got it put together.
And yes, it runs
[youtube]hDCfZUIMom8[/youtube]
Guy takes three KA24 heads, cuts them up, and assembled them into a single DOHC head for a Nissan L28 inline 6.
I remember when he started talking about this project back in 2005 or so, and in 2007 he got it put together.
And yes, it runs
[youtube]hDCfZUIMom8[/youtube]
10-26-2010, 03:28 PM
#4
Troll & Run
Join Date: Sep 2007
Location: Hampton Roads
Posts: 22,993
Likes: 0
Received 0 Likes
on
0 Posts
Re: Three KA24s = one DOHC Inline 6 head
was this cheaper than any of the inline 6 motors that are already made? the fabrication looks like shit, or maybe he just didn't clean anything?
10-26-2010, 03:47 PM
#5
nortaP
Thread Starter
Join Date: Feb 2009
Posts: 13,272
Likes: 0
Received 0 Likes
on
0 Posts
Re: Three KA24s = one DOHC Inline 6 head
The car it was installed into was pretty ratted out.
The guy wanted to keep an L series inline 6 for some reason. If you want a DOHC head there are two options.
The ultra rare factory 2.0 DOHC which used a different block. Less than 500 of these Zs were made and only sold in Japan
Or the OS Giken head which is like $12,000
10-26-2010, 04:23 PM
#8
Registered member
Join Date: Nov 2004
Posts: 6,252
Likes: 0
Received 0 Likes
on
0 Posts
Re: Three KA24s = one DOHC Inline 6 head
There are so many engineering problems involved in this that I would love to know how he solved them. . . although its a safe bet he probably just threw it together. . .
