local miata owners, post pics of your cars
#2021
Officially Official
Join Date: Aug 2007
Location: Klofron
Posts: 1,980
Likes: 0
Received 0 Likes
on
0 Posts
Re: local miata owners, post pics of your cars
Terry, if it means anything the bottom side to side "play" was little to none in the "1st gen" set i had.
#2023
+RepCarebearCrew
Join Date: Dec 2006
Location: Getting lap dances.
Posts: 17,085
Likes: 0
Received 0 Likes
on
0 Posts
Re: local miata owners, post pics of your cars
with a spacer filled in, diameter will be solved, but it does slide side to side prolly a 18th or 16th of a inch, NOT a whole lot of travel side to side
#2024
fuckin smart
Join Date: Jan 2010
Location: Virginia Beach
Posts: 3,069
Likes: 0
Received 0 Likes
on
0 Posts
Re: local miata owners, post pics of your cars
22 - yeah that should give it enough room for the spacers, and theyll fit like a glove
#2025
Officially Official
Join Date: Aug 2007
Location: Klofron
Posts: 1,980
Likes: 0
Received 0 Likes
on
0 Posts
Re: local miata owners, post pics of your cars
The early set i had had spacer/sleeves to fit the bolt. without them (the spacer/sleeves) the hole was too big and there was about an 1/8th inch of play on each side.
#2026
Patron
Join Date: Aug 2004
Location: Virginia Unfortunately
Posts: 7,803
Likes: 0
Received 0 Likes
on
0 Posts
Re: local miata owners, post pics of your cars
Ding Dong over at R-speed forgot to send me the spacers over. This is why it didn't fit. Grant if you could send me that coil back when you get a chance. I can email you a return label.
I am going down to Atlanta on the 18th and we will test fit and play around with a bunch of different configurations.
We will then put the car on Road Atlanta the 20th and test them baby's out.
That mixed in with a bunch of road driving in downtown atlanta
#2027
TwoWheels YearRound
Join Date: Mar 2010
Location: Inside the Beltway
Posts: 12,705
Likes: 0
Received 0 Likes
on
0 Posts
Re: local miata owners, post pics of your cars
Less talk more pics
#2028
Registered Member
Join Date: Jun 2009
Location: Hampton
Posts: 399
Likes: 0
Received 0 Likes
on
0 Posts
Re: local miata owners, post pics of your cars
have always loved that smurf...that thing is pure sex!
#2029
Officially Official
Join Date: Aug 2007
Location: Klofron
Posts: 1,980
Likes: 0
Received 0 Likes
on
0 Posts
Re: local miata owners, post pics of your cars
suspension/wheels almost done.
Broken bolt is slowing be down...
Broken bolt is slowing be down...
#2030
V NewYearsResolution
Join Date: Jun 2009
Location: Mechanicsville VA
Posts: 762
Likes: 0
Received 0 Likes
on
0 Posts
Re: local miata owners, post pics of your cars
So far I have done valve cover gasket, fuel filter with new hoses, brakes and rotors, plugs and wires, trans fluid, diff fluid with LSD additive, oil change, both accessory belts, 3rd brake light, power steering flush, brake fluid flush and bleed, coolant, battery, e-brake tightened, unplugged the door buzzer, glued the instrument cluster bezel for now.
Tomorrow I'm balancing the wheels that were on it until I get my old daisies back from powder coating. I'm also going to make some new brackets at work for the Jackson racing intake on it because it's just sort of sitting in there now. After that it's time to move it outside and clean the engine bay, clean and shampoo the interior, and wash and waz the exterior. Whenever I get a new car I do a good 3-4 hour wax on it, but I've never done before and after pics. I think I will tomorrow, pics to come soon.
I plan on driving it till March 23rd when I will put it back in the garage and put on new racelands and the white powder coated daisies, rear finish panel, instrument cluster bezel, relocate the cig lighter to the center consul and put a garage door opener in its place, timing belt change, vacuum line kit from moss miata, do an alignment at work, voodoo shift knob and e-brake handle, new steering wheel, new soft top brackets, front strut tower bar, and if there is any money left the FM Butterfly brace.
Please PM me if anyone has some of the parts I need for sale.
Tomorrow I'm balancing the wheels that were on it until I get my old daisies back from powder coating. I'm also going to make some new brackets at work for the Jackson racing intake on it because it's just sort of sitting in there now. After that it's time to move it outside and clean the engine bay, clean and shampoo the interior, and wash and waz the exterior. Whenever I get a new car I do a good 3-4 hour wax on it, but I've never done before and after pics. I think I will tomorrow, pics to come soon.
I plan on driving it till March 23rd when I will put it back in the garage and put on new racelands and the white powder coated daisies, rear finish panel, instrument cluster bezel, relocate the cig lighter to the center consul and put a garage door opener in its place, timing belt change, vacuum line kit from moss miata, do an alignment at work, voodoo shift knob and e-brake handle, new steering wheel, new soft top brackets, front strut tower bar, and if there is any money left the FM Butterfly brace.
Please PM me if anyone has some of the parts I need for sale.