sr20 vacuum lines
#1
Registered Member
Thread Starter
Join Date: Mar 2006
Posts: 573
Likes: 0
Received 0 Likes
on
0 Posts
sr20 vacuum lines
I am swapping a s14 sr20 into my s14 240 but i dont know where all the vacuum lines from the intake manifold and throttle body go. I have searched all over the internet and everything i find is for a s13 sr20.
I have pictures
I know where these 2 go
I dont know where these go
I am not sure about these either
this is the factory "T" in between my FPR and intake manifold....does my boost gauge connect to the end of the "T"
any help will be greatly appreciated. I will be using my factory charcoal canistor so please help.
I have pictures
I know where these 2 go
I dont know where these go
I am not sure about these either
this is the factory "T" in between my FPR and intake manifold....does my boost gauge connect to the end of the "T"
any help will be greatly appreciated. I will be using my factory charcoal canistor so please help.
#2
Re: sr20 vacuum lines
Goes something like this, except if you are using a BOV then use the line going to the recirc. Thats not a factory T, its there to be the source of boost gauge VAC. Same with that reducer that comes off the T.
Thread
Thread Starter
Forum
Replies
Last Post