sr20 vacuum lines
 

I am swapping a s14 sr20 into my s14 240 but i dont know where all the vacuum lines from the intake manifold and throttle body go. I have searched all over the internet and everything i find is for a s13 sr20.

I have pictures

I know where these 2 go http://i81.photobucket.com/albums/j2...%20240SX/1.jpg

I dont know where these go
http://i81.photobucket.com/albums/j2...%20240SX/2.jpg

I am not sure about these either
http://i81.photobucket.com/albums/j2...%20240SX/4.jpg

this is the factory "T" in between my FPR and intake manifold....does my boost gauge connect to the end of the "T"
http://i81.photobucket.com/albums/j2...%20240SX/5.jpg
http://i81.photobucket.com/albums/j2...%20240SX/6.jpg

any help will be greatly appreciated. I will be using my factory charcoal canistor so please help.

Re: sr20 vacuum lines
 

Goes something like this, except if you are using a BOV then use the line going to the recirc. Thats not a factory T, its there to be the source of boost gauge VAC. Same with that reducer that comes off the T.

http://img.photobucket.com/albums/v4...Car/S14Vac.jpg

Re: sr20 vacuum lines
 

hah damn thats sick lol, were did you find that or did you make it, i could have used that on my friends sr swap

Re: sr20 vacuum lines
 

Made it.

Re: sr20 vacuum lines
 

This is a sick diagram thats has answered just about all my questions. I just have one more quick question. Is that where the BOV goes?
http://i81.photobucket.com/albums/j2...%20240SX/9.jpg

Re: sr20 vacuum lines
 

Thats just where the stock recirc valve is on the S14 SR. You can put the BOV anywhere on the hot or cold pipe.