hey man, havent been on here a long time, just figureed i would drop you a line and see whats up, and ask if you know any place loacally that sells -AN lines and fittings... i'll still putting the motor together, had a bit of a nightmare with the "shop" that put my ish together the first time, i'm not haveing to go back and re-build the whole thing pretty much. hit me up some time, thanks man.

You riding today? Never told me where your located?

yeah thats true lol. not like i cant always change my mind and sell the twins, plenty of people that would buy it,

yeah looked into it too, and the two kits are pretty much the same price, i'll just have two inlets on the inside of the intercooler and one out. not a big deal.

haha nice, well after the motor decided to loose compression across the whole right bank, it was time to pull the motor. reused the stock block but had in punched .020 over and all new internals with some BA heads. it was supposed to be done before i left for Mississippi and deployment, but the motor just showed up to the shop either today or yesterday. i should get some time to come back to VA and pick it up and drive it a bit but that wont be till like the middle of AUG or so..... you'll deff have to check it out, i'm going with twing GT30R turbos and shooting for about 600 or so to the wheels.

hows the new motor coming? mine shows up tomorrow but i just left for deployment so i wont get to drive it for some time

nicwe vid man. impressive. so this is all on stock internals and turbos?

hey bro where is this vid of yours that you where talking about

aight

aight well if tomorrows good for you and your near yorktown, then i could swing by.
pm me your number.