Local place for exhaust gaskets?

[Blasphemous]

Where can I go to get a new exhaust gasket? I need either a 3" or 2.5" universal 2-bolt gasket, with the holes 180 degrees apart.

[Heat]

good luck, I tried finding a 3" flange locally and came up empty after calling every store listed in the phonebook.

[reXer]

I would think places that do custom exhaust work would have a way to make gaskets... but I really don't know. Call around.

[Blasphemous]

Originally posted by Heat
good luck, I tried finding a 3" flange locally and came up empty after calling every store listed in the phonebook.
I just need a gasket, not a new flange.

[MGBRaceman]

I may sell something over at pep boys, however I have a feeling that most of our flange gaskets are a max of 2.5. I'll check.

[Vortech8pSI]

Aaron, make a stencil of what you need, and take it to advance of muffler shop....i did that for mine before i found em buried in the box....

[Heat]

Originally posted by FastX7
I just need a gasket, not a new flange.

and? they go hand in hand

[Boosted2003]

i got 3 hole 3inch one when i got my car exahsut on.. but i think any local place part store should have it or trie goign ot domestics shop they might have better and bigger gaskets for there good size piping they use...

[nickyroo]

this doesnt answer your question but i went by muffler king way down jefferson to get an exhaust gasket between my test pipe and my exhaust system and the guy lifted my car up on the lift then tried to say he wouldnt put it back down and was going to have a cop fine me for not having a cat haha. i almost got in a fight with a 50 year old fat-man at muffler king in the middle of the day. deefffinitely dont go there if your car is modded.

[Boosted2003]

that sucks man

[lightningd]

i'd hate to say it, but i had to get some gaskets for my exhaust from PAS. i got the goods and left as sson as possible. they were the only place i could find that had GReddy gaskets.

[nastyone]

well if you give me a good idea about what it looks like and i could probably punch it out of soft aluminum or brass thats what i did for my turbo and it stoped leaking i was blowing all kinds of paper and steal braid ones out from advance and autozone and from hahn that cost me 30 bucks