PDA

View Full Version : Ground on thermastat



hondazccivic
09-27-2003, 01:12 PM
Hey, I can't find the ground on my thermastat from my wire harness. Is anyone able to tell me where exactly the ground comes from, I think this may be why my car is making a weird noise. It wont start but when I turn the power on it makes a weird high pitch squeeking noise, and the power flickers very fast.
-Aaron-

Ninety7GSX
09-27-2003, 02:17 PM
alternator belt is slipping

hondazccivic
09-27-2003, 02:32 PM
Hey, I don't think it would be the alt. belt slipping because it doesn't even turn over man. But the squeeking is gone, now it just makes a loud click when I try to start it.

Bert
09-27-2003, 02:40 PM
by not having that wiring harness grounded will cause the check engine light to flicker when the key is in position II...you need to find that ground on the wiring harness and ground it to the thermostat housing...that grounds some of the sensors....

Ninety7GSX
09-28-2003, 12:24 AM
It's clicking cause your battery doesn't have enough power to turn the motor.

Tighten or replace the belt. Charge the battery and then you can worry about a sensor that doesn't affect whether or not the car runs. Also, your engine is grounded, your thermostat housing bolts to the engine, therefore the thermostat housing is grounded. The extra ground is normally there just in case, if it floats your boat take a wire and bolt it to the body somewhere close by and to the bolt on the thermostat housing.

hondazccivic
09-28-2003, 12:49 PM
Hey, I connected the thermastat ground, but where are there other grounds?, honestly guys, I really need this car running soon.
-Aaron-

hondazccivic
09-28-2003, 12:56 PM
Hey, the squeaking noise is gone, so it's one less thing to worry about, i think i just have to find all the grounds and screw them on.
-Aaron-

a92civicxjdmb16
09-29-2003, 03:54 PM
them grounds shouldnt keep u from starting ur engine up,but it will throw a code due to some sensors not grounded, there should be a ground near the starter to the frame of the car and u said u here clicking but it doesnt turn over u might want to see if ur battery is strong, test ur starter, or worst case it might be a locked motor, let me know what happens

reddevil94
09-29-2003, 04:01 PM
yo, this happened to me, run a direct ground wire from your starter to your negative side of the battery, this is happening, because your starter is not grounded real well, I did this and my car started and ran fine after.....

hondazccivic
09-29-2003, 06:07 PM
Hey, guys, I have an update of my situation. I go to start it and the engine is turning but it's not runing. I hear a poping noise if I hold it long enough, I am getting spark, I checked that, I tried putting a little bit of gas in the cylinder, but didn't notice a difference. Can anyone help me with this one?
-Aaron-

a92civicxjdmb16
09-29-2003, 06:30 PM
well if u said u hear a poping noise and it was turning over but not starting u might want to check ur timing. Also u said u put gas in A cyclinder,how? U might want to try some starter fluid and if that works then check ur whole fuel system

hondazccivic
09-29-2003, 11:34 PM
You take out the spark plug and put a little bit of gas in it, thas how mechanics check to see if there is a fuel problem. What the hell is starter fluid though?

Ninety7GSX
09-29-2003, 11:48 PM
Carb spray/starting fluid u can get it almost anywhere.

We soak the air filter in gas. Works better but I wouldn't do it to a K&N or anything like that.

Pouring gas into each cylinder will flood it pretty easy.

hondazccivic
09-30-2003, 08:24 AM
It's just a couple of drops, so where do I put this starter fluid? How much does it go for?

a92civicxjdmb16
09-30-2003, 12:08 PM
no more than 3 bucks, take ur air filter off let someone crack the car while u spray in ur intake tube thats it

CHAHONDA
09-30-2003, 12:32 PM
did you get all of the ground wires taken care of?

i was about to say that id check it out for you but canada is a bit far from me!!!!:rolleyes:

hondazccivic
09-30-2003, 02:27 PM
I found somethin weird though, I have a totally smashed tps, and the computer is not picking it up, you guys think that could be why it is not starting? It aint throwing any codes at me now, so it is getting better. Let me know guys
-Aaron-

a92civicxjdmb16
09-30-2003, 03:27 PM
well im not sure if ur tps well stop u from starting cause i disconnectec mine before and started it only thing that happened it was idling at 1500 instead of around 7-800, if u find something else let us know.
Has the motor ever ran before or did u buy it from someone?
Did u check ur timing?
you might want to do a compression test

hondazccivic
09-30-2003, 04:55 PM
Hey, this is getting to be a long thread so i am gonna make a new one that has more to do with what i need help with.